28
VQT2D32
Preparation
Setup
7
Setting date and time
When the unit is turned on for the first time, a message asking you to set the date and time will appear.
Select [YES] and perform steps 2 to 3 below to set the date and time.
¬Change the mode to .
1 Select the menu. (l 23)
2 Touch the date or time to be set,
then set the desired value using
/.
≥ The year will change as follows:
2000, 2001, ..., 2039, 2000, ...
≥ The 24-hour system is used to display the time.
≥ appears on the right top of the screen
when [SET WORLD TIME] (l 30) is set to
[HOME], while appears when it is set to
[DESTINATION].
3 Touch [ENTER].
≥ The clock function starts at [00] seconds.
≥ A message prompting for World time setting
may be displayed. Perform the World time
setting by touching the screen. (l 30)
≥ Touch [EXIT] or press the MENU button to
complete the setting.
Changing the date and time display mode
Select the menu. (l 23)
[SETUP] # [DATE/TIME] # desired display
style
≥ The date and time disappear from the screen
after being displayed for a few seconds.
[SETUP] # [CLOCK SET] # [YES]
[DATE] [D/T]
[OFF]
12:34
15. 11. 2009
15. 11. 2009
To Next Page
Loading...
