EasyManua.ls Logo

Panasonic HDC-TM10 - Page 125

Panasonic HDC-TM10
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
125
VQT2D32
White round spots like
soap bubbles appear on
the recorded picture.
If you take a picture with the
flash in a dark place or indoors,
white round spots may appear
on the picture caused by the
flash reflecting of particles of
dust in the air. This is not a
malfunction.
A characteristic of this is that the number of round spots
and their position differ in every picture.
“ERROR OCCURRED.
PLEASE TURN UNIT OFF,
THEN TURN ON AGAIN.”
is displayed.
The unit has automatically detected an error. Restart the
unit by turning off and on the power.
The power will be turned off in about 1 minute if the power
is not turned off and on.
Repair is needed if it is repeatedly displayed even if it is
restarted. Detach the power connected, and consult the
dealer who you purchased this unit from. Do not attempt to
repair the unit by yourself.
VIERA Link does not
work.
[Setting on this unit]
Connect with a HDMI mini cable (optional). (l 88)
Press the MENU button, then touch [SETUP] # [VIERA
Link] # [ON]. (l 88)
Turn the power to the unit off and then back on again.
[Setting on other devices]
Depending on HDMI terminal of the TV, the input channel
may not switch automatically. In this case, use the remote
control for the TV to switch input. (For details on how to
switch input, please read the operating instructions for the
TV.)
Check the VIERA Link setting on the connected device.
Set the setting to control the VIERA Link of the TV to [Off]
once, and the back to [On] again. (Refer to the operating
instructions of the TV for details.)
When connected by the
USB cable, this unit is not
detected by the PC.
Select another USB terminal on the PC.
Check the operating environment. (l 106)
Connect the supplied USB cable again after restarting the
PC and turning on this unit again.
When the USB cable is
disconnected, an error
message will appear on
the PC.
To disconnect the USB cable safely, double-click the
( ) icon in the task tray and follow the instructions on the
screen.
Problem Check points

Table of Contents

Related product manuals