Resetting the
c
amera
Use this procedure if you have
trouble setting up the camera.
1 Plug in the camera.
2 Using an object with a thin tip,
press and hold the reset
button on the back of the
camera for about 10 seconds,
then release the button when
the camera beeps.
R T
he camera’s settings are
reset.
3 Wait for the camera’s LED to
light in green.
Note:
R After resetting the camera, you
cannot use the camera again
until it is set up. Refer to the
relevant page in this section to
set up the camera.
22
For a
ssistance, please visit http://shop.panasonic.com/support
Setup
HN1003W_(en_en)_0302_ver001.pdf 22 2018/03/02 14:18:13
To Next Page
Loading...
