90
Cleaning Setting
F1. Drain Water
Water is pumped through the system to clean the pipes. The water is
drained into the drip tray.
1
Add 100
g
of water to the water tank.
Ensure drip tray is empty.
2
Tap Cleaning pad once.
3
Turn the Dial to select F1. Drain Water.
4
Press the Dial to confirm the selection.
5
Press the Dial to start.
Note
Caution!
1. Only run this program with 100
g
of water in the tank.
2. Do not remove the drip tray during the drain water program.
3. Empty the drip tray and rinse with running water after the program
has finished.
If the drain water program is used directly after a steam cooking
program, hot water may be drained into the drip tray.
To Next Page
Loading...
