Figure 3-23
Please refer to the following sheet for detailed information.
Parameter Function
Enable You need to check the box to enable VMD function.
Working Period
Here you can set arm/disarm period. Click on set button to open
period setup menu.
System only memorizes one event during the anti-dither period. The
value ranges from 0s to 100s.
Here you can set VMD region and its sensitivity and area. The
default covers all regions. You must click on save before enabling
When record is enabled, you can trigger VMD to activate record.
Record Delay
System can delay the record for specified time after alarm ended.
The value ranges from 10s to 300s.
Send Email
If you enabled this function, System can send out email to alert you
when alarm occurs and ends.
You need to check the box here so that system can backup VMD
snapshot file.
To Next Page
Loading...
