7 Wall Mounting
7.1 Wall Mounting
1. Connect the handset cord.
2. Insert the 3 tabs of the wall mounting adaptor into the designated
openings in the base.
3. Fasten the wall mounting adaptor to the base with 1 screw.
(Recommended torque: 0.4 N·m [4.08 kgf·cm/3.54 lbf·in] to 0.6 N·m [6.12
kgf·cm/5.31 lbf·in])
4. Connect the cables to the unit, and run the cables through the grooves in
the wall mounting adaptor, as shown in the illustration below. Cables
marked with "a" may also be run through the corresponding lower
grooves.
5. Drive the 2 screws into the wall either 83 mm (3 1/4 in) or 100 mm (3
15/16 in) apart, and mount the unit on the wall.
83 mm
(3
1/4 in)
100 mm
(3
15/16 in)
Washer
Drive the screw
to this point.
7 Wall Mounting
29
To Next Page
Loading...
