Panasonic KX-FL501 - Page 24

1.15.2.1. MAINTENANCE LIST
NO. OPERATION CHECK REMARKS
1 Document Path Remove any foreign matter such as paper. —
2 Rollers If the roller is dirty, clean it with a damp cloth then dry
thoroughly.
Refer to (P.25).
3 Platen Roller If the platen is dirty, clean it with a damp cloth then dry
thoroughly. Remove the paper and film cartridge before
cleaning.
—
4 Sensors Document sensor (PS102), Paper feedsensor (PS103),
Hook switch (SW200), Top cover open switch (SW101)
Resist sensor (PC201) and Paper exit sensor (PS50).
Paper sensor (PS1)Confirm the operation of the sensors.
See (P.23) and (P.124).
5 Glass If the glass is dirty, clean them with a dry soft cloth. Refer to (P.25).
6 Abnormal, wear and tear
or loose parts
Replace the part. Check if the screws are tight on all parts. —
1.15.2.2. MAINTENANCE CYCLE
No. Item Cleaning Cycle Replacement
Cycle Procedure
1 Separation Roller 3 months 7 years*
(100,000 documents)
Refer to (P.128).
2 Separation Rubber (Ref. No. 11) 3 months 7 years (100,000 documents) Refer to (P.124).
3 Document Feed Roller (Ref. No. 7) 3 months 7 years (100,000 documents) Refer to (P.124).
4 Separation paper (Ref. No. 163) 3 months 7 years (100,000 documents) Refer to (P.128).
5 Exit Roller(Ref.No.197) 3 months 7 years (100,000 documents) Refer to (P.131).
* These values are standard and may vary depending on usage conditions.
24
KX-FL501