32
KX-FP207FX-S/FP218FX-S
6.5.5. Film End Sensor (SW1003)
When a film is set, the SW turns ON, and the input signal of IC501-45 pin (Digital Board) becomes a low level. When there is no
film, the SW turns OFF, and the input signal of IC501-45 pin (Digital Board) becomes a high level.
6.5.6. Motor Position Sensor (SW1004)
This sensor is a detection switch for recording the position of the CAM.
6.5.7. Hook Switch (SW1501)
When the handset is lifted, the switch turns ON, and the signal at pin 43 of IC501 becomes low.
When the handset is returned, the switch turns OFF, and the signal at pin 43 of IC501 becomes high.
SW Signal (IC501-45 pin)
No film OFF High level
Set a film ON Low level
Signal (IC501-119 pin)
Home position Low level
Other High level
SW Signal (IC501-43 pin)
ON-Hook OFF High level
OFF-Hook ON Low level
To Next Page
Loading...
