Panasonic KX-FP207FX-S

99
KX-FP207FX-S/FP218FX-S
OK means "can set".
NG means "can not set".
Note:
•
*1
: Power is OFF/ON after changing this set value.
• Refer to Service Function Table (P.63) for descriptions of the individual codes.
Example:
If you want to set value in the "004 Print confirmation report", press the dial key number 1,2 or 3 corresponding to the Set Value
you want to select. (1:ERROR / 2:ON / 3:OFF)
570 Break % select 1:61% 2:67% 61% OK
571 ITS auto redial time set 00~99 11 OK
572 ITS auto redial line disconnection time set 001~999sec 040sec OK
573 Remote turn-on ring number (KX-FP207) 00~99 10 OK
573 Remote turn-on ring number (KX-FP218) 00~99 10 OK
574 Dial tone detect check 1:ON / 2:OFF OFF OK
580 TAM continuous tone detection (KX-FP218) 1:ON / 2:OFF ON OK
590 FAX auto redial time set 00~99 05 OK
591 FAX auto redial line disconnection time set 001~999sec 065sec OK
592 CNG transmit select 1:OFF / 2:ALL / 3:AUTO ALL OK
593 Time between CED and 300 bps 1:75ms / 2:500ms / 3:1sec 75ms OK
594 Overseas DIS detection 1:1st / 2:2nd 1st OK
595 Receive error limit value 1:5% / 2:10% / 3:15% / 4:20% 10% OK
596 Transmit level set -15~00dbm -10dbm OK
598
*1
Receiving Sensitivity -20~-48dbm -42dbm OK
599 ECM frame size 1:256 byte / 2:64 byte 256 byte OK
710 Memory clear except History data --------- --------- NG
717 Transmit speed select (KX-FP207) 1:9600/ 2:7200/ 3:4800/ 4:2400 9600bps OK
717 Transmit speed select (KX-FP218) 1:14400 / 2:12000 / 3:9600/4:7200/ 5:4800/
6:2400
14400bps OK
718 Receive speed select (KX-FP207) 1:9600/ 2:7200/ 3:4800/ 4:2400 9600bps OK
718 Receive speed select (KX-FP218) 1:14400 / 2:12000 / 3:9600/4:7200/ 5:4800/
6:2400
14400bps OK
722 Redial tone detect 1:ON / 2:OFF ON OK
745 Power on film feed 1:ON / 2:OFF ON OK
763 CNG detect time for friendly reception 1:10s / 2:20s / 3:30s 30s OK
773 DIS-DCS interval 1:500msec / 2:200msec 200ms OK
774 T4 timer 00~99 x 100ms 00ms OK
784 Voice prompt (KX-FP218) --------- --------- NG
815 Sensor & VOX test --------- --------- NG
841 Digital SP-Phone RX & TX check (KX-FP218) --------- --------- NG
852 Print test pattern --------- --------- NG
853 Top margin 1~9 mm 5 OK
861 Paper Size 1:A4 / 2:LETTER A4 OK
874 DTMF ON time 06~20 × 10msec 10 × 10msec OK
875 DTMF OFF time 06~20 × 10msec 10 × 10msec OK
880 History list 1:Start --------- NG
881 Journal 2 1:Start --------- NG
882 Journal 3 1:Start --------- NG
961 TEL/FAX pseudo ring back time 01~10 sec 07 sec OK
962 TEL/FAX pseudo ring back time and bell time 05~30 sec 10 sec OK
991 Remote Setup list 1:Start --------- OK
994 Remote Journal list 1:Start --------- OK
995 Remote Journal 2 list 1:Start --------- OK
996 Remote Journal 3 list 1:Start --------- OK
998 Remote History list 1:Start --------- OK
999 Remote Service list 1:Start --------- OK
Code Function Set Value Default Remote Set-
ting