Panasonic kx-ft902

3. Preparation
14
Volu me
3.3 Adjusting volume
Ringer volume
4 levels (high/medium/low/off) are available.
While the unit is idle, press {A} or {B}.
L If any documents are in the document
entrance, you cannot adjust the volume.
Confirm that there are no documents in the
entrance.
To turn the ringer OFF
1. Press {B} repeatedly to display “RINGER
OFF= OK?”.
2. Press {SET}.
L When a call is received, the unit will not ring
and will display “INCOMING CALL”.
L To turn the ringer back ON, press {A}.
Handset receiver volume
3 levels (high/middle/low) are available.
While using the handset, press {A} or {B}.
Speaker volume
8 levels (high to low) are available.
While using the monitor/speakerphone, press
{A} or {B}.
Voice guidance volume (KX-FT908 only)
9 levels (high to off) are available.
While listening to voice guidance, press {A}
or {B}.
Answering device volume (KX-FT908 only)
9 levels (high to off) are available.
While listening to recorded messages, press
{A} or {B}.
Initial Programming
3.4 Date and time
You must set the date and time.
1 Press {MENU}.
SYSTEM SET UP
2 Press {SET}.
PRESS[()]&[SET]
3 Press {<} or {>} repeatedly to display the
following.
SET DATE & TIME
4 Press {SET}.
L The underbar shows the position of the
cursor.
M:01/D:01/Y:04
5 Enter the current month/date/year by
selecting 2 digits for each.
Example: August 10, 2004
Press {0}{8} {1}{0} {0}{4}.
M:08/D:10/Y:04
6 Press {SET}.
TIME: 12:00AM
7 Enter the current hour/minute by selecting 2
digits for each. Press {*} repeatedly to
select “AM” or “PM”.
Example: 3:15PM (12 hour clock entry
only)
1. Press {0}{3} {1}{5}.
TIME: 03:15AM
2. Press {*} repeatedly to display “PM”.
TIME: 03:15PM
8 Press {SET}.
L The next feature will be displayed.
9 Press {MENU} to exit.
{A}{B} {SET}
{
MENU}
{SET}{<}{>}
FT-902-904-908HK.book Page 14 Tuesday, June 15, 2004 5:44 PM