3. Preparation
16
Note:
L To enter another character located on the
same number key, press {>} to move the
cursor to the next space.
To enter your logo
Example: “BILL”
1. Press {2} 2 times.
LOGO=B
2. Press {4} 3 times.
LOGO=BI
3. Press {5} 3 times.
LOGO=BIL
4. Press {>} to move the cursor to the next
space and press {5} 3 times.
LOGO=BILL
To correct a mistake
Press {<} or {>} to move the cursor to the
incorrect character, and make the correction.
To delete a character
Press {<} or {>} to move the cursor to the
character you want to delete and press {STOP}.
L To erase all of the characters, press and hold
{STOP}.
To insert a character
1. Press {<} or {>} to move the cursor to the
position to the right of where you want to
insert the character.
2. Press {MUTE} to insert a space and enter
the character.
To select characters using {A} or {B}
Instead of pressing the dial keys, you can select
characters using {A} or {B}.
1. Press {A} repeatedly to display the desired
character. Characters will be displayed in the
following order:
1 Uppercase letters
2 Number
3 Symbol
4 Lowercase letters
L If you press {B}, the order will be
reversed.
2. Press {>} to insert the character.
3. Return to step 1 to enter the next character.
{4} GHI g h i 4
{5} JKLj kl 5
{6} MNOmn o 6
{7} PQRSpqr s 7
{8} TUVt uv8
{9} WX Y Z w x y z 9
{0} 0( ) <>! " #$
%& ¥ @ @^ ’ →
{FLASH} To enter a hyphen.
{MUTE} To insert a space.
{STOP} To delete a digit.
Keys Characters
FT-902-904-908HK.book Page 16 Tuesday, June 15, 2004 5:44 PM
To Next Page
Loading...
