Panasonic KX-HCM110A

BecertaineachpinislocatedoverthecorrectpadonthePCB.
2.ApplyfluxtoallofthepinsontheIC.
3.Beingcarefultonotunsolderthetackpoints,slidethesolderingiron
alongthetipsofthepinswhilefeedingenoughsoldertothetipsothat
itflowsunderthepinsastheyareheated.
15.3.REMOVINGSOLDERFROMBETWEENPINS
1.Addasmallamountofsoldertothebridgedpins.
2.Withahotiron,useasweepingmotionalongtheflatpartofthepinto
drawthesolderfrombetweentheadjacentpads.
60