Timer
The timer can be used to play sound from the
monitor unit after the specified number of
hours has passed. The timer can be set to
sound once or repeat at specified intervals.
1 MMENUN
2 MbN: “Timer” a MOKN
3 M
bN: Select “Once” or “Repeat”. a
MOKN
4 M
bN: Specify when the timer is set for. a
MOKN a MMENUN
Note:
R Timers play for 1 minute. Press MOKN to
stop a timer. Press and hold MOKN for
5 seconds to stop timers from repeating.
R If the monitor unit is turned off after setting
a timer:
– “Once”: The timer will be cancelled.
– “Repeat”: The timer will be played once
the specified time has passed from when
the monitor was turned on again.
Managing camera units
Up to 3 additional camera units can be
registered to the monitor unit.
Registering a camera unit
Additional camera units can be registered to
the monitor unit.
Monitor unit:
1 MMENUN
2 M
bN: “Camera Management” a MOKN
3 M
bN: “Add Camera” a MOKN
R An operation guide is displayed. Press
MOKN to continue.
R Complete the following step within
90 seconds.
Camera unit:
1 Press and hold M
N for 3 seconds until
the LED indicator starts blinking.
Note:
R A message is displayed on the monitor unit
to show if the registration was successful or
not, and a beep sounds.
Resetting the settings for a
camera unit
The camera unit settings saved on a monitor
unit can be reset.
Note:
R All camera unit settings except for
registration settings are reset.
R Settings for all camera units registered to
the monitor unit are reset.
1 MMENUN
2 M
bN: “Camera Management” a MOKN
3 M
bN: “Reset” a MOKN
4 M
N: “Yes” a MOKN
R A beep sounds from the monitor unit
when resetting is completed.
Cancelling a camera unit
You can cancel camera units that are no
longer needed.
Note:
R Only the currently connected camera unit is
cancelled. To cancel other camera units,
select the displayed camera unit (page 21)
and then cancel that camera unit.
1 MMENUN
2 M
bN: “Camera Management” a MOKN
3 M
bN: “Delete Camera” a MOKN
4 M
To Next Page
Loading...
