Panasonic KX-MB271 - Setting the Original; Help Function (KX-MB781 Only); Adjusting Volume (KX-MB781 Only)

1. Introduction and Preparation
10
Detailed operating instructions are on the CD-ROM, or can be viewed at www.panasonic.com/help
Document Requirements
1.6 Setting the original
1.6.1 Using the scanner glass
1
Open the document cover (1).
2 Place the document FACE DOWN on the scanner
glass (2), aligning the top left of the document with
the corner to which the m mark points.
3 Close the document cover.
1.6.2 Using the auto document feeder
1
Insert the document (up to 20 pages) FACE UP into
the feeder until a single beep is heard.
2 Adjust the width of the document guides (1) to fit
the actual size of the document.
He lp Bu tton
1.7 Help function (KX-MB781
only)
The unit contains helpful information on the following
topics which can be printed for reference purposes, as
follows:
– “BASIC SETTINGS”
– “FEATURE LIST”
– “DIRECTORY”
– “FAX SND/RCV”
– “COPIER”
– “Q and A”
– “ERRORS”
– “REPORTS”
– “CALLER ID”
1 Press {MENU} repeatedly to display “HELP”.
2 Press {<} or {>} repeatedly to display the desired
item. i {SET}
3 Press {MENU} to exit.
Volu me
1.8 Adjusting volume (KX-MB781
only)
Before adjusting volume, set the operation mode to fax
mode (page 9).
Ringer volume
While the unit is idle, press {V} or {^}.
L If there are any documents in the document
entrance, you cannot adjust the volume. Confirm that
there are no documents in the entrance.
To turn the ringer OFF
Press {V} repeatedly to display “RINGER OFF= OK?”.
i {SET}
L The unit will not ring.
L To turn the ringer back ON, press {^}.
Ringer pattern
L You can select one of 3 ringer patterns (feature
#161).
Monitor volume
While using the monitor, press {V} or {^}.
1
2
1
MB271-781-PFQW2640ZA-QRG-en.book Page 10 Tuesday, May 22, 2007 12:31 PM