EasyManua.ls Logo

Panasonic KX-MB271 - Connections; Dialing Mode (KX-MB781 Only); Selecting the Operation Mode (Scan;Copy) (Fax: KX-MB781 Only)

Panasonic KX-MB271
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1. Introduction and Preparation
9
Detailed operating instructions are on the CD-ROM, or can be viewed at www.panasonic.com/help
Connecti ons and Set up
1.3 Connections
Caution:
L When you operate this product, the power outlet
should be near the product and easily
accessible.
* The pictured model is KX-MB781.
Note:
L If any other device is connected to the same
telephone line, this unit may disturb the network
condition of the device (KX-MB781 only).
Using surge protectors
L The warranty does not cover damage due to power
line surges or lightning. For additional protection, we
recommend using surge protectors (9).
1.4 Dialing mode (KX-MB781
only)
If you cannot dial, change this setting according to your
telephone line service.
1 {MENU} i {#}{1}{2}{0}
DIALING MODE
=TONE [V^]
2 Press {1} or {2} to select the desired setting.
{1} PULSE: For rotary/pulse dial service.
{2} TONE (default): For tone dial service.
3 {SET}
4 Press {MENU} to exit.
1.5 Selecting the operation mode
(Scan/Copy) (Fax: KX-MB781
only)
You can select the desired mode by pressing one of the
following buttons.
* The pictured model is KX-MB781.
{SCAN}: Select this mode when using the unit as a
scanner for the computer.
{COPY}: Select this mode when using the unit as a
copier.
{FAX} (KX-MB781 only): Select this mode when
using the unit as a fax machine.
1 Power cord
L Connect to a power outlet
(120 V, 60 Hz).
2 Telephone line cord
*1
L Connect to a single telephone line jack (RJ11).
3 [EXT] jack
*1
L You can connect an answering machine or an
extension telephone. Remove the stopper if
attached.
4 Answering machine (not included)
*1
5 Handset unit (optional) connection jack
*1
L You can connect the optional handset unit.
Remove the seal if attached.
6 Network router/Network hub (not included)
*1
L Also connect networked computers.
7 To the internet
*1
8 LAN cable (not included)
*1
L To assure continued emission limit compliance,
use only shielded LAN cable (category 5 straight
cable).
*1 KX-MB781 only
Important notice for the USB connection
L Do NOT connect the USB cable until prompted by
the Multi-Function Station (page 12).
4
7
1
2
8
3
6
9
5
9
MB271-781-PFQW2640ZA-QRG-en.book Page 9 Tuesday, May 22, 2007 12:31 PM

Other manuals for Panasonic KX-MB271

Related product manuals