Panasonic KX-TCD320FX - Screen Saver Mode; Setting the Date and Time

Preparation
13
Setting the date and time
Important:
L Confirm that the AC adaptor is connected.
L Ensure that w is not flashing. If the
handset is in screen saver mode, w is not
displayed. Press {ih} to turn the
display on.
1 Press $ (middle soft key).
2 Select Y, then press ,.
3 Select “Time Settings”, then press
,.
4 Select “Set Date & Time”, then press
,.
5 Enter the current day, month and year by
selecting 2 digits for each.
Example: 17 May, 2005
Press {1}{7} {0}{5} {0}{5}.
6 Enter the current hour and minute by
selecting 2 digits for each.
L You can select “AM”, “PM” or 24-hour
time entry by pressing {*} repeatedly.
Example: 3:30 PM
Press {0}{3} {3}{0}, then press {*}
repeatedly until “03:30 PM” is
displayed.
7 Press ,.
8 Press {ih}.
Note:
L To correct a digit, press {<} or {>} to
move the cursor, then make the
correction.
L The date and time may be incorrect after a
power failure. In this case, set the date
and time again.
TCD320FX(e).book Page 13 Tuesday, January 18, 2005 1:25 PM