Panasonic KX-TCD320FX - Receiving a Message

SMS (Short Message Service)
41
5 Press $, select “Edit Message”,
press ,, then continue from step 4,
“Writing and sending a new message”,
page 40.
Erasing saved messages
1
Press $ (middle soft key).
2 Select X, then press ,.
3 Select “Send List”, then press ,.
4 Press {e} or {v} repeatedly to select
the message, then press ,.
5 Press $, select “Erase”, then press
,.
L To erase all messages, select “Erase
All”, then press ,.
6 Select “Yes”, then press ,.
7 Press {ih}.
Receiving a message
When an SMS message is received:
– a tone is heard (if the ringer is turned off,
this tone is not heard)
– “Receiving SMS Message” is
displayed
– h is displayed
– the total number of new (unread) SMS
messages is displayed next to h if the
screen saver (page 12) is turned off
Reading a received message
1
Press $ (middle soft key).
2 Select X, then press ,.
3 Select “Receive List”, then press
,.
4 Press {e} or {v} repeatedly to select a
message.
L Messages which have already been
read are indicated by a “Q”, even if
they were read using another handset.
L To erase a message, press w,
select “Yes”, then press ,.
5 Press , to read the message
content.
Note:
L To call the message sender, press {C}
or {s}.
L If “SMS Full” is displayed, new SMS
messages cannot be received. Erase
unnecessary messages (page 41).
L If you receive a message from a party
saved in the handset phonebook, the
stored name is displayed.
L Some SMS service providers attach a 1-
digit number to the message sender’s
phone number, and sender names stored
in the handset phonebook may not be
displayed as a result.
Replying to a message
1
While reading a received message,
press $ (middle soft key).
2 Select “Reply”, then press ,.
3 Enter a message (page 43), then press
,.
4 Edit the destination phone number
and/or press ,.
5 Continue from step 6, “Writing and
sending a new message”, page 40.
Editing/forwarding a message
1 While reading a received message,
press $ (middle soft key).
2 Select “Edit Message”, then press
,.
3 Continue from step 4, “Writing and
sending a new message”, page 40.
Erasing received messages
1
While reading a received message,
press $ (middle soft key).
TCD320FX(e).book Page 41 Tuesday, January 18, 2005 1:25 PM