8.1. Engineering Mode
8.1.1. Base Unit
Important:
Make sure the address on LCD is correct when entering new data. Otherwise, you may ruin the unit.
1). Press .
2). Select "Initial Setting" using {^} or {V}
then press or
{>}.
H/S key operation H/S LCD
3). Enter "7", "2", "6", "2", "7", "6", "6", "4".
Note: 7262 7664 = PANA SONI
(see letters printed on dial keys)
*
5). Enter "
٨
", "
٨
", "
٨
", "
٨
" (Address). (*1)
7). Press , a long confirmation beep
will be heard.
8).
Press to return to standby mode.
After that, turn the base unit power off and then power on.
Note: * To enter "Set dial mode", press
or
{>} at " Set tel line".
6). Enter "
㧖
", "
㧖
" (New Data). (*1)
4). Select "Write EEP" using {^} or {V}
then press or
{>}.
Default Data
New Data
INT
Caller List
^
V
^
V
Initial setting
BACK
^
V
Set tel line
BACK
BACK
BACK
CLEAR
^
V
Set dial mode
Select "Set tel line" using {^} or {V}
then press or
{>}.
Service Mode
Read EEP
Write EEP
Set Addr.:
_ _ _ _ _ _
Set Addr.:
Set Addr.:
M
M
M
CLEAR
{OFF}
SELECT
PLAY
INT
SELECT
SELECT
SELECT
SELECT
SELECT
SELECT
SELECT
SELECT
PLAY
It is necessary to turn on the power of base unit.
Soft keys
Navigator key/
?
(Volume) key
{CALL WAIT}/
{FLASH}
{OFF}
Dial keypad
To Next Page
Loading...
