Direct Commands
68
During programming:
When “
” or “
” is displayed, press the right soft key to save the new
settings.
To exit programming, press [OFF].
• If you press the direct command incorrectly, press [OFF], then re-enter
programming mode by pressing [MENU].
• For function details, see the corresponding pages.
Menu item Command Selection items Page
Ringer tone
(Base unit)
[0] [*] [1] [1]–[3] : Tone pattern 1-3
[4]–[7] : Melody pattern 1-4
p. 21
Incoming call tone
(Base unit)
[0] [*] [2] [1] : On [2] : Twice [0] : Off p. 61
Room monitor
(Base unit)
[0] [*] [3] [1] : On [0] : Off p. 50
Handset registration [0] [0] [1] Go to Step 5 on page 70. –
Handset deregistration [0] [0] [2] [3] [3] [5] p. 69
Talking Call Display
(Base unit)
[0] [*] [4] [1] : On [0] : Off p. 30
SAVE
OK
TG5230C_English.fm Page 68 Tuesday, May 11, 2004 9:08 AM
To Next Page
Loading...
