– 6 –
Programming via direct commands
You can program most features using “direct commands”—special codes that take you
directly to the feature you wish to program and allow you to select the desired setting.
There is no need to scroll through the unit’s menus.
1 Press {MENU} (center of joystick), then press {#}.
2 Enter the desired feature code (shown below).
3 Enter the desired setting code (shown below).
4 Press {SAVE}.
5 Press {OFF} to exit programming mode.
Direct commands chart
Feature Feature code Setting code
Set dial mode {1} {2} {0} {1}: Pulse {2}: Tone
LCD contrast (Handset) {1} {4} {5} {1}–{6}: Level 1–6
Ringer volume (Handset) {1} {6} {0} {1}: Low {2}: Medium
{3}: High {0}: Off
Ringer tone
Tone & Melody (Handset)
{1} {6} {1} Scroll to “Tone & Melody”, then
press {SELECT}.
{1}–{3}: Tone 1–3
{4}–{7}: Melody 1–4
Talking Caller ID
(Handset)
{1} {6} {2} {1}: On {0}: Off
Auto talk {2} {0} {0} {1}: On {0}: Off
Voice enhancer {2} {7} {0} {1}: On {0}: Off
Message alert {3} {4} {0} {1}: On {0}: Off
Ringer volume (Base unit) {*} {1} {6} {0} {1}: Low {2}: Medium
{3}: High {0}: Off
Ringer tone (Base unit) {*} {1} {6} {1} {1}–{3}: Tone 1–3
{4}–{7}: Melody 1–4
Talking Caller ID (Base
unit)
{*} {1} {6} {2} {1}: On {0}: Off
Enter direct No.
:
TG5561_5566_QG(e).fm Page 6 Friday, February 4, 2005 2:44 PM
To Next Page
Loading...
