,nnect the headset ta the headset jack as
~~n~~~t the AC adaptor. install scraps using
e it dQ~n ((a)
then slide
-ed.
1) Remain on the line and briefly explain to the dispatcher the reason for
the
call.
2) Perform such activities in the off-peak hours, such as early morning or late evenings.
This device complies with Part I5 of the FCC Rules. Operation is subject to the following
two conditions: (I ) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Privacy of ~~mrnuni~~~ions may not be ensured when using
this
phone.
es or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this device.
IS equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
cotnmuni~ations. Rowever, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
-. Increase the separation between the equipment and receiver.
-.’ Cannect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-I Consult the dealer or an experienced radio/TV technician for help.
Operating near 2.4Gl-b electrical appliances may cause interference. Move away from
the electrical appliances.
To comply with FCC RF exposure requireme~~ts, the handset should be carried with the
specific belt-clip provided for the handset to ensure compliance. Other non-tested belt-
clips or similar body-worn accessories may not comply, therefore, should be avoided.
This equipment is hearing aid compatible as defined by the FCC in 47 CFR Section
68.316.
_-..._.._. - .-.-
To Next Page
Loading...
