Problem Cause/solution
Caller information is not
a
nnounced.
R The ringer volume for landline is turned off. Adjust the
ringer volume (page 43, 47).
R The ringer volume for cellular line is turned off. Adjust the
ringer volume (page 41, 46).
R The unit which is not selected to ring for cellular calls
does not announce caller information. To change the
selection, see page 17.
R The Talking Call Display feature is turned off. Turn it on
(page 43, 47).
R The ring as cell mode is set to “On (without Talking
CID)”. To change the mode, see page 17.
R The number of rings for the answering system is set to “2
rings” or “Toll saver”. Select a different setting
(page 67).
R Your unit does not announce caller information while the
other devices such as headset or handsets are engaged
in a call.
I cannot dial the phone number
e
dited in the caller list.
R The phone number you dialed might have been edited
incorrectly (for example, the long distance “1” or the area
code is missing). Edit the phone number with another
pattern (page 55).
Time on the unit has shifted. R I
ncorrect time information from incoming Call Display
changes the time. Set the time adjustment to “Manual”
(off) (page 43).
The 2nd caller’s information is
n
ot displayed during an outside
call. (Visual Call Waiting
feature does not function.)
R In order to use Call Display, Call Waiting, or Visual Call
Waiting, you must first contact your phone service
provider and subscribe to the desired service.
After subscribing, you may need to contact your phone
service provider again to activate this specific service,
even if you already subscribed to both Call Display and
Visual Call Waiting services.
For assistance, visit www.panasonic.ca/english/support
77
Useful Information
To Next Page
Loading...
