Operating the answering system
MMENUN a MbN: “Answering device” a
MSELECTN
Key Operation
MDN or MCN Adjust the receiver/speaker volume
(during playback)
1 or MFN Repeat message (during
playback)
*1
2 or MEN Skip message (during playback)
3 Enter the “Settings” menu
4 Play new messages
5 Play all messages
6 Play greeting message
76 Record greeting message
8 Turn answering system on
MPAUSEN
Pause message
*2
9 or
MSTOPN
Stop recording
Stop playback
0 Turn answering system off
*4
*3
Erase currently playing message
*5 Erase all messages
*6 Reset to a pre-recorded greeting
message
*1 If pressed within the first 5 seconds of a
message, the previous message is played.
*2 To resume playback:
MbN: “Playback” a MSELECTN
*3 You can also erase as follows:
MPAUSEN a MbN: “Erase” a MSELECTN
a MbN: “Yes” a MSELECTN
Calling back (Caller ID subscribers only)
n Using a landline:
1 Press MPAUSEN during playback.
2 MbN: “Call back” a MSELECTN
n Using a mobile line:
1 Press MPAUSEN during playback.
2 MbN: “Call back (Mobile)” a
MSELECTN
R The unit starts dialling when:
– only 1 mobile phone is paired.
– a specific line is set to make mobile
calls (page 19).
3 MbN: Select the desired mobile phone. a
MSELECTN
Editing the number before calling back
n Using a landline:
1 Press MPAUSEN during playback.
2 MbN: “Edit & Call” a MSELECTN
3 Edit the number. a M
N
n Using a mobile line:
1 Press MPAUSEN during playback.
2 MbN: “Edit & Call” a MSELECTN
3 Edit the number.
4 MMOBILEN
R The unit starts dialling when:
– only 1 mobile phone is paired.
– a specific line is set to make mobile
calls (page 19).
5 MbN: Select the desired mobile phone. a
MSELECTN
Erasing all messages
1 MMENUN#325
2 MbN: “Yes” a MSELECTN a MOFFN
Advanced new message
alerting features
Audible message alert
This feature allows the base unit to beep to inform
you of a new message arrival when new
messages are recorded. The base unit beeps 2
times every minute until you listen to the
messages, if the “Base unit beep” setting is
turned on. The default setting is “Off”.
You can configure this setting using either the
base unit or one of the handsets.
Handset / Base unit
1 MMENUN#339
2 MbN: Select the desired setting. a MSAVEN
3 Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
60
Answering System for Landline
TGF38xAZ(en)_0319_ver001.pdf 60 2015/03/19 21:57:18