Panasonic KX-TGF882 - Frequently Asked Questions

– 10 –
Frequently asked questions
Question Cause/solution
Why is _ displayed? LThe handset is too far from the base unit. Move closer.
LThe base unit’s AC adaptor is not properly connected. Reconnect AC
adaptor to the base unit.
LThe handset is not registered to the base unit. Register it.
1 Handset: {MENU}(13)
2 Base unit: Press and hold {LOCATOR} for about 5 seconds.
3 Handset: Press {OK}, then wait until a long beep sounds.
Why am I unable to pair a cellular
phone to the base unit?
LDepending on the compatibility of the cellular phone, you may not be
able to pair it to the base unit. For more information, please visit:
http://shop.panasonic.com/bluetooth-phone
LConfirm that the Bluetooth feature of your cellular phone is turned on.
You may need to turn this feature on depending on your cellular
phone.
Why is there no dial tone?
(cellular line)
LThe cellular phone has not been paired to the base unit. Pair the
cellular phone.
How can I increase the handset
volume level?
LPress the volume key {^} repeatedly while talking.
Why is the conversation noisy or
cutting off?
LTry to relocate the base unit so that distance to the handset is
minimized.
LIf the same problem occurs even if the handset is next to the base
unit, please visit: http://shop.panasonic.com/support
Can I add another accessory
handset to my base unit?
LYes, you can add up to 6 handsets (including the handset(s) sold with
your base unit) to a single base unit.
LTo purchase additional accessory handset(s) (KX-TGFA88),
please visit: http://shop.panasonic.com/support
TTY users (hearing or speech impaired users) can call 1-877-833-
8855.
Can I keep the batteries charging
all the time?
LYou can leave the handset on the charger anytime. This will not harm
the batteries.
How can I answer a call waiting
call (2nd call)?
LPress {FLASH} on the handset or {CALL WAIT} on the base unit
when you hear the call waiting tone.
TGF88x(en)_QG.fm Page 10 Friday, November 1, 2019 1:08 PM