Note:
R I
f your phone service provider requires
additional devices in order to make and receive
calls, such as a modem, you may still not be
able to make and receive calls even if the base
unit’s power backup feature is functioning.
Base unit battery status when a power failure
o
ccurs
Icon Battery status
Power backup mode is on.
Battery power is low.
*
1
*1
I
f
begins flashing on the base unit, replace
t
he batteries with new ones as soon as
possible. If you replace Ni-MH batteries with
alkaline batteries, insert the Ni-MH batteries
into the base unit again after the power is
restored so that they will be recharged.
Battery saving mode setting
T
his feature allows the base unit to reduce its
power consumption by limiting the available
functions and therefore extend battery life during a
power failure.
The following settings are available:
– “On”: The unit will work as a standard
telephone. Only the corded handset can be
used to make and receive calls. (You cannot
use the base unit display, phonebook,
one-touch dial, answering system,
s
peakerphone, Bluetooth functions, etc.)
The base unit display is blank.
– “Off” (default): You can use the full functions
of the base unit, but battery life is not extended.
The brightness level for the base unit display is
lowered.
Base unit
1 MM
ENUN#150
2 MbN: Select the desired setting.
3 MSAVEN a MEXITN
Note:
R Once the battery saving mode is set to “On”,
the unit rings with the volume level 1 even if the
ringer volume for the base unit is set to “Off” to
let you know an incoming call is being received.
Ni-MH battery performance (optional batteries)
w
hen operating on backup battery power
Operation
Saving mode
Off On
In continuous use 1.5 hours
m
ax.
5 hours
max.
Not in use (standby) 2 hours
m
ax.
6 hours
max.
Note:
R B
attery performance depends on the type of
batteries.
R Actual battery performance depends on usage
and ambient environment.
Note when setting up
Note for connections
R The AC adaptor must remain connected at all
times. (It is normal for the adaptor to feel warm
during use.)
R The AC adaptor should be connected to a
vertically oriented or floor-mounted AC outlet.
Do not connect the AC adaptor to a horizontally
oriented AC outlet that faces the floor, such as
an AC outlet installed on a ceiling or under a
table, as the weight of the adaptor may cause it
to become disconnected.
For assistance, please visit http://shop.panasonic.com/support
11
Getting Started
To Next Page
Loading...
