3 I
f your headset PIN is “0000”, go to step 4.
If your headset PIN is not “0000”, press
MCLEARN, then enter your headset’s PIN.
R Typically, default PIN is “0000”. Refer to
your headset’s operating instructions.
4 Press MOKN, then wait until a long beep
sounds.
5 Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
R When
is displayed on the base unit, the
h
eadset is available for use.
Connecting/disconnecting a Bluetooth headset
I
f you cannot connect the headset and base unit
using the headset, you can connect using the unit.
To use your headset with another Bluetooth
device such as a cellular phone, you may need to
disconnect it from the base unit.
Important:
R Make sure that the headset is turned on.
Handset / Base unit
1 T
o connect/disconnect:
MMENUN#622
R A long beep sounds.
2 Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Unpairing a Bluetooth headset
Y
ou can cancel a pairing of the headset that is
stored to the base unit.
Handset / Base unit
1 MM
ENUN#612
2 MbN: “Yes” a MSELECTN
R When the headset is unpaired, the
disappears from the base unit display.
3 P
roceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Operating a Bluetooth headset using
a
landline
Important:
R Refer to your headset’s operating instructions
for details.
Making landline calls with your headset
Base unit
1 P
ress your headset’s button referring to your
headset’s operating instructions.
2 Dial the phone number using the base unit
after hearing the dial tone on your headset.
3 When you finish talking, press your headset’s
button referring to your headset’s operating
instructions.
Answering landline calls with your headset
T
o answer a landline call, press your headset’s
button.
When you finish talking, press your headset’s
button.
Note:
R If you cannot hang up the call using your
headset, press MZN on the base unit 2 times.
Call sharing between your headset and the
h
andset
Important:
R To activate this feature, you should set call
sharing mode to on beforehand (page 50).
n While the handset is on a landline call:
To join the conversation with your headset,
press your headset’s button.
n While your headset is on a landline call:
To join the conversation with the handset, press
M
N.
Switching between the base unit and your
h
eadset
You can switch between the base unit and your
headset:
– during a landline call with the base unit.
– during an intercom call between the base unit
and handset.
– while listening to messages recorded on the
base unit answering system.
n To switch to your headset:
Press M
N
on the base unit.
n To switch to the base unit:
Lift the corded handset to talk with the corded
handset.
or
Press MZN to talk with the speakerphone.
64
For assistance, please visit http://shop.panasonic.com/support
Using Bluetooth® Devices
To Next Page
Loading...
