Problem Cause/solution
The unit does not emit the
specified number of rings.
R The number of rings decreases by 1 from the specified
number of rings in below situations:
– the first ring is turned off (“No”) (page 40).
– answer by voice command is set to “On” (page 35).
Menu list
Problem Cause/solution
The display is in a language I
cannot read.
R Change the display language (page 17).
I cannot register a handset to a
base unit.
R The maximum number of handsets (6) is already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 66).
Battery recharge
Problem Cause/solution
The handset beeps and/or
flashes.
R Battery charge is low. Fully charge the batteries (page 13).
I fully charged the batteries, but
–
still flashes,
–
is displayed, or
– the operating time seems to
be shorter.
R Clean the battery ends (
, ) and the charge contacts
with a dry cloth and charge again.
R It is time to replace the batteries (page 12).
Making/answering calls, intercom
Problem Cause/solution
is displayed.
R The handset is too far from the base unit. Move closer.
R The base unit’s AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset is not registered to the base unit. Register it
(page 66).
Noise is heard, sound cuts in
and out.
R You are using the handset or base unit in an area with
high electrical interference. Re-position the base unit and
use the handset away from sources of interference.
R Move closer to the base unit.
R If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the base unit and
the telephone line jack. Contact your DSL/ADSL provider
for details.
For assistance, please visit http://shop.panasonic.com/support
89
Useful Information
To Next Page
Loading...
