R T
his feature is not available while using the
speakerphone.
R When both the “Equalizer” setting and
noise reduction are activated,
is
s
hown on the display.
Recording a telephone
c
onversation (2-way recording)
This unit can record a telephone
conversations during landline calls.
1 Press MMENUN during a landline call.
2 MbN: “2 way recording” a MSELECTN
R The total recordable time is displayed.
R The unit announces to both parties that
the recording will start.
R The unit starts recording.
3 To stop recording, press MMENUN a
MbN: “Stop recording” a MSELECTN
R You can continue the conversation
with the outside caller.
Note:
R When recording is completed:
– The total number of recordings will be
added to the number of messages in the
answering system.
– MEN on the base unit flashes.
– “New message” is displayed.
– Audible message alert sounds on base
unit.
R To listen to the recorded conversation, refer
"Listening to messages", page 77.
R 2 way recording is not available during
conference calls.
R The recording will end in the following
situations:
– When MFLASHN is pressed.
– When the hold or intercom feature is
used.
R When memory is/becomes full:
– “Memory full” is shown on the
display.
– An error tone sounds.
Call share
Y
ou can join an existing outside call.
n W
hile another unit is on a cellular call:
1 To join the conversation, press
MCELLN.
R You can join the conversation in the
following situations.
– Only 1 cellular phone is paired.
– A specific line is set to make
cellular calls (page 23).
2 MbN: Select the corresponding cellular
phone. a MSELECTN
n While another unit is on a landline call:
To join the conversation, press M
N.
N
ote:
R When another user joins the conversation,
the interrupt tone sounds.
R A maximum of 3 parties (including 1 outside
party) can join a conversation using 2
extensions. (3-way conference)
R To prevent other users from joining your
conversations with outside callers, turn call
sharing mode off (page 58).
R A 2nd party cannot join an outside call that
is being recorded (page 27).
Transferring calls, conference
c
alls
Outside calls can be transferred or a
conference call with an outside party can be
made:
– between handsets
– between a handset and the base unit
1 During an outside call, press MMENUN.
2 MbN: “Intercom” a MSELECTN
3 MbN: Select the desired unit. a MSELECTN
R If you select “Voice paging”, the
call will be switched from the
ear-receiver mode to the
speakerphone mode.
4 Wait for the paged party to answer.
R If the paged party does not answer,
press MBACKN to return to the outside
call.
5 To complete the transfer:
Press MOFFN.
To establish a conference call:
MMENUN a MbN: “Conference” a
MSELECTN
For assistance, please visit http://shop.panasonic.com/support
27
Making/Answering Calls Using the Handset
To Next Page
Loading...
