Y
Programming using the Handset
27
Document Version 2010-07
*1 If you program these settings using one of the handsets, you do not need to program the same item
using another unit.
Programming using the direct commands
1
1 (centre of joystick) i {#}
2 Enter the desired feature code.
3 {V}/{^}: Select the desired setting. i M
L This step may vary depending on the feature being programmed.
L To exit the operation, press {i}.
Note:
L In the following table, < > indicates the default settings and ( ) indicates lines you need to select for the
settings.
Initial settings
"
Ringer Setup Ringer Volume 14
Ringtone
(Line 1: 8 max.)
–
Interrupt tone –
Set Date/Time
*1
–31
Caller Barred
*1
–30
Auto Intercom –45
LCD Contrast ––
Keytones ––
Auto Talk –14
New Msg. Alert –44
Registration Register H.set 41
Cancel Register 41
Base Unit PIN
*1
–31
Handset Name –31
Select Language –12
Software version
*1
–32
Phonebook
C
––20
Feature Feature
code
Setting code System
setting
*1
Page
Auto Intercom {2}{7}{3}{1}: On (Ringer On)
{2}: On (Ringer Off)
{0}: <Off>
–45
Auto Talk
*2
{2}{0}{0}{1}: On
{0}: <Off>
–14
Base Unit PIN {1}{3}{2} – r 31
Caller Barred {2}{1}{7} – r 30
Cancel Register {1}{3}{1} ––41
DHCP
*3
{5}{0}{0}{1}: <On>
{0}: Off
r –
Main menu Sub-menu 1 Sub-menu 2 Page
To Next Page
Loading...
