:
Programming using the Base Unit (KX-TGP550 only)
34
Document Version 2012-01
*1 If you program these settings using the base unit, you do not need to program the same item using a
handset.
Programming using the direct commands
1
{MENU} (middle soft key) i {# }
2 Enter the desired feature code.
3 {V}/{^}: Select the desired setting. i {SAVE}
L This step may vary depending on the feature being programmed.
L To exit the operation, press {EXIT}.
Note:
L In the following table, < > indicates the default settings and ( ) indicates lines you need to select for the
settings.
Initial settings
"
Date and time
*1
–38
Call block
*1
–37
LCD contrast ––
Change language –10
Software version
*1
–38
Phonebook
C
––23
Caller list
W
––42
Feature Feature
code
Setting code System
setting
*1
Page
Call block {2}{1}{7} – r 37
Change language {1}{1}{0}{1}: <English>
{2}: Español
{3}: Français
–10
Date and time {1}{0}{1} – r 38
DHCP
*2
{5}{0}{0}{1}: <On>
{0}: Off
r –
Embedded web {5}{3}{4}{1}: On
{0}: <Off>
–40
Interrupt tone
*3
{2}{0}{1}{1}: <On>
{0}: Off
– 18, 46
IP settings
*2
{5}{0}{1} – r –
LCD contrast
(Display contrast)
{1}{4}{5}{1} – {6}: Level 1–6 <3> – –
Phonebook {2}{8}{0} ––23
Ringer tone {1}{6}{1} (Line 1:
8 max.)
{1} – {6}: Tone <1>-6
{7} – {9}: Melody 1-3
––
Ringer volume
*4
{1}{6}{0}{1} – {3}: Level 1–<3>
{0}: Off
–17
Software version {1}{5}{6} – r 38
Main menu Sub-menu 1 Sub-menu 2 Page
To Next Page
Loading...
Need help?
General
