2
PRIMUSBUSINESS.CA
PRIMUS BUSINESS SERVICES
|
HOSTED PBX
|
PANASONIC TGP600 TPA60 TPA65 QUICK SETUP
Setting Up the Base Unit (KX-TGP600)
1. Take the Ethernet cable (included with your unit) and plug one end to the
port on the base unit. Plug the other end of the cable to your internet
modem, router, or switch.
2. Plug the AC adapter (Part No. PQLV219) into the base unit. Press the plug
firmly to make sure it is in place. There is a hook at the bottom of the unit to
secure the cable in place to prevent it from being accidentally pulled out.
Plug the AC adapter into an electrical outlet.
3. Once everything is connected, the base unit will go through an auto-
configuration process, which may take up to 10 minutes. You are ready to
make and receive calls when the STATUS light indicator turns to solid
green.
NOTE:
The configuration may take up to 10 minutes, and may reboot several times.
Leave the base unit plugged in for at least 10 minutes before making any
changes.
When the base unit is first connected to power, the STATUS indicator will
be solid red. If the STATUS indicator is off, make sure the AC adaptor and
Ethernet cable are properly plugged in, and verify your network device
(modem, router, switch) is on and functioning.
If the STATUS indicator remains red or amber after 10 minutes, try
plugging the base unit directly to your Internet modem instead of through
your routers, switches, or firewalls.
To Next Page
Loading...
