*When an intercom transmission is not in use, the waveform of (D)
becomes the same burst signal as (C).
2. Data Reception
The data that is transmitted to the telephone line from another set
is input via T701 in reverse order of the data transmission (D). This
burst signal passes BPF701 to separate from the audio signal and
then only 455 kHz is extracted (E) at pin 5 of IC701.
This burst signal is amplified and demodulated at pin 4 of IC701 (I).
The amplified burst signal (J) is input to pin 32 of the
microcomputer IC801.
49
To Next Page
Loading...
