FF
RINGER
3 Set the DIALING MODE selector to TONE.
If you cannot dial, set to PULSE.
4 Set the RINGER selector to HIGH, LOW or
OFF.
(Ex. “LOW” is selected.)
2-A Making Calls
1
When the unit rings, lift the handset.
2 When finished talking, hang up.
2-B Answering Calls
1
Lift the handset.
2 Dial a phone number.
If you misdial, hang up and start again from
step 1.
3 When finished talking, hang up.
To redial the last number dialed
Lift the handset. Press
(REDIAL).
To adjust the receiver volume (4 levels)
while talking
To increase, press
(^).
To decrease, press (_).
After hanging up, the volume level will be saved.
2 Operation 3 Special Features
3-A For Call Waiting Service Users
Press (FLASH) if you hear a call-waiting tone
while talking.
The first call is put on hold and you can answer the
second call.
To return to the first caller, press (FLASH) again.
3-B Temporary Tone Dialing
(For Rotary or Pulse Service Users)
Press ($) (TONE) before entering access
numbers which require tone dialing.
The dialing mode changes to tone. You can enter
numbers to access answering services, electronic
banking services, etc. When you hang up, the
mode will return to pulse.
The unit can be mounted on a wall phone plate.
1 Press the tabs in the direction of the arrows
(), then remove the wall mounting adaptor
().
Wall Phone
Plate
Hooks
Environment—do not place the unit in a room
where the temperature is less than 5C (41F)
or greater than 40C (104F). Allow 10 cm (4)
clearance around the unit for proper ventilation.
Avoid excessive smoke, dust, mechanical
vibration, shock, or direct sunlight.
Routine care—wipe the unit with a soft cloth. Do
not use benzine, thinner, or any abrasive powder.
If there is any trouble—disconnect the unit from
the telephone line and connect a known working
phone. If the known working phone operates
properly, have your unit repaired by one of the
authorized Panasonic Factory Service Centers.
If the known working phone does not operate
properly, consult your telephone company.
Printed in Malaysia
PNQX1287TA
FM0808NK50818
Panasonic Corporation of North America
Two Riverfront Plaza, Newark, NJ 07102-5490
For your future reference
Serial No.
(found on the bottom of the unit)
Date of purchase
Name and address of dealer
Integrated Telephone System
Operating Instructions
Model No. KX-TS500
Pulse-or-tone dialing capability
PLEASE READ BEFORE USE AND SAVE.
Handset .......one
Order No.
PQJXE0401Z (Black)
PQJXE0411Z (White)
Handset Cord ... one
Order No.
PQJA212N (Black)
PQJA212M (White)
Telephone Line Cord
..............one
Order No.
PQJA10075Z
Accessories (included)
4-C Helpful Information
When set to OFF, the unit will not ring.
3 Connect the telephone line cord. Mount the
unit, then slide down.
Fasten the cord to prevent it from being
disconnected.
2
2 Tuck the telephone line cord inside the
wall mounting adaptor, and push it in the
direction of the arrow ( and ).
The word “UP WALL” should face upward.
1
2
KX-TS500W
Attach your purchase receipt here.
For extra orders, call
1-800-332-5368.
If you need assistance with setup or operation
1 Visit our website:
http://www.panasonic.com/support
2 Contact us via the web at:
http://www.panasonic.com/contactinfo
3 TTY users (hearing or speech impaired users) can
call 1-877-833-8855.
4-B Troubleshooting
When you ship the product
Carefully pack your unit, preferably in the original
carton.
Attach a letter, detailing the symptom, to the outside
of the carton.
Symptom
Send the unit to Panasonic Exchange Center, prepaid
and adequately insured.
Do not send your unit to the Panasonic
Corporation of North America listed on the back
cover or to executive or regional sales offices.
These locations do not repair consumer products.
To temporarily set the
handset down during
a conversation, place
it as shown here.
4-D Specifications
Power Source: From telephone line
Dimensions (H x W x D):
Approx. 96 mm x 150 mm x 200 mm
(3
25
⁄
32
5
29
⁄
32
7
7
⁄
8
)
Mass (Weight): Approx. 475 g (1.05 lb.)
Dialing Mode: Tone (DTMF)/Pulse
Operating Environment: 5°C – 40°C (41F – 104F)
Specifications are subject to change without notice.
For assistance, visit our website:
http://www.panasonic.com/support
for customers in the USA or Puerto Rico.
Problem Remedy
The unit
does not
work.
Check the settings (1-B).
The call
cannot be
connected
even if
you dialed
correctly.
Check whether the DIALING
MODE selector setting is correct
or not (1-B).
The unit
does not
ring.
The RINGER selector is set to
OFF. Set to HIGH or LOW (1-B).
If you
cannot
solve your
problem
Visit our website:
http://www.panasonic.com/support
Contact us via the web at:
http://www.panasonic.com/contactinfo
PNQX1287TA_eng_lsp.indd 1 2018/07/30 10:11:30
To Next Page
Loading...
