13
Preparation
For assistance, please call: 1-800-211-PANA(7262)
Voice Mail Tone
If your voice mail service sends a voice mail tone after a new message has
finished recording, set to “ON”. “ ” icon will flash on the display if a
message was recorded in your mailbox. You will hear a series of voice mail
tones then a dial tone after lifting the handset.
(Contact your service provider about your service.)
Set to “OFF” when:
—you do not subscribe to a voice mail service.
—your voice mail service does not send a voice mail tone, or
—the unit is connected to a PBX.
Your phone comes from the factory set to “ON”.
Make sure that the handset is on the cradle.
1
Press
[FUNCTION/EXIT]
.
2
Scroll to “
VM TONE DETECT ?
” by
pressing
[]
or
[]
.
3
Press
[ENTER]
.
4
Select “
ON
” or “
OFF
” by pressing
[]
or
[]
.
5
Press
[ENTER]
.
• You can exit the programming mode any time by pressing
[FUNCTION/EXIT]
.
SAVE PHONEBOOK ?
VM TONE DETECT ?
▼
▼
:ON
▼
▼
SAVED
E-PQQX14369ZA.book 13 ページ ２００４年１２月１０日 金曜日 午後４時１分
To Next Page
Loading...
