Panasonic KX-TSC62SXW - Assembly Instructions; Replacing the Base Unit LCD

16
KX-TSC62SXB/KX-TSC62SXW
9.2. Assembly Instruction
9.2.1. How to Replace the Base Unit LCD
Note:
• Make sure to cut the length of the rubber of the soldering iron to become 23mm to 25mm.
• Preheat the soldering iron for 10 minutes for the Rubber of Soldering Iron to reached around 180~200C.
• The illustrations are simplified in this page. They may differ from the actual product.
P. C. Board
LCD
New LCD
Peel off the HSC (Heat Seal Connector) from
the P.C. board, in the direction of the arrow.
Use some IPA alcohol to gently remove glue
stain on the P.C. board.
2
1
Fit the heatseal of the new LCD.
0.2 mm
0.2 mm
Horizontal Interval
Tolerance
Vertical Interval
Tolerance
OK
NG
NG
NG
(Horizontal interval tolerance is
more than 0.2 mm.)
(Vertical interval tolerance is
more than 0.2 mm.)
(Inclined)
If interval tolerance between
center lines is less than
0.2 mm, it is o.k.