Panasonic KX-TVM50 - Page 46

Subscriber’s Manual
46
6. Go on-hook.
Changing Device Numbers
1. Log in to your mailbox.
• See 2.1 Logging in to Your
Mailbox if necessary.
2.
3. Enter the desired device number
(1–3).
4. to change the assigned
number.
• To delete the assigned number,
press [3] then go on-hook to
finish.
5. Enter the outside line access
number needed for making outside
calls.
• To store an extension number,
simply enter the extension
number then continue from
step 7.
6. Enter the outside telephone
number (including area code if
needed).
• To insert a pause or special
command in the middle of the
telephone number, pause
momentarily while entering the
telephone number. The VPS
will announce a list of available
options, for example, "To insert
a pause, press [5]. Press [4] to
continue entering the
telephone number.".
• If you insert a beeper (pager)
display command here, the
VPS will prompt callers to enter
their telephone numbers. Caller
telephone numbers can then
be sent to your beeper (pager).
This feature may be disabled
for your mailbox.
7. to accept.
8. if the assigned number is a
telephone number.
if the assigned number is a
beeper (pager) number.
9. Go on-hook.
Note
• If your PBX uses PRI lines, you may
need to enter [#] at the end of outside
telephone numbers. Consult your
System Administrator for more
information.
5
3
1
2
1
2