Preparation/Basic
18
DVQX2263 (ENG)
3 Insert the battery E in the correct direction.
• The [CHARGE] indicator F lights up and charging begins.
∫ About the [CHARGE] indicator
• When the [CHARGE] indicator flashes
– The battery temperature is too high or too low. It is recommended to charge the battery again
in an ambient temperature of between 10 oC and 30 oC (50 oF and 86 oF).
– The terminals of the charger or the battery are dirty. In this case, wipe them with a dry cloth.
• Always use genuine Panasonic batteries (DMW-BLC12PP).
• If you use other batteries, we cannot guarantee the quality of this product.
• Being careful about the battery orientation, insert all the way until you hear a locking sound and
then check that it is locked by lever A.
∫ To remove
Push the lever A in the direction of the arrow to remove.
• Turn the camera off and wait for the “LUMIX” display on the monitor to clear
before removing the battery.
• Remove the battery after use.
¥ Do not use any other USB connection cables except the supplied one.
¥ Do not use any other AC adaptors except the supplied one.
¥ The AC adaptor (supplied) and USB connection cable (supplied) are for this camera only. Do
not use them with other devices.
On: Charging.
Off: Charging has completed.
(After charging is complete, disconnect the AC adaptor (supplied) from
the power outlet and remove the battery.)
Battery Insertion
DC-G95DPP-DVQX2263_eng.book 18 ページ ２０２２年３月１５日 火曜日 午後２時３９分
To Next Page
Loading...
Need help?
General
