22
6 Service Mode
6.1. Error Code Memory Function
1. General Description
This unit is equipped with history of error code memory function, and can be memorized 16 error codes in sequence from the
latest. When the error is occurred more than 16, the oldest error is overwritten in sequence.
The error code is not memorized when the power supply is shut down forcibly.
The error code is memorized to Flash-ROM when the unit has just before powered off.
2. How to Display
There are two types of display methods. (refer to the step 2 below)
• Preparation
Attach the fully charged Battery, and insert the memory card to slot1.
Set the mode dial to [ P ] (Program AE Mode).
• Step 1. The temporary cancellation of “Initial Settings”:
Set the drive mode dial to [ Single ], while pressing [ Playback ] button and [ AF/AE LOCK ] button simultaneously, turn the
power on.
• Step 2. Execute the error code display mode:
[ Display method by pressing the buttons simultaneously ]
Press [ Playback ] button, [ MENU/SET ] button and “[ LEFT ] of Cursor buttons” simultaneously with the step 1 condition.
*The display is changed as shown below when the above buttons are pressed simultaneously.
Normal display → Error code display → Camera information display → Normal display → .....
[ Display method from the menu display ]
Select [ ERR CODE DISP ] from the setup menu and then press [ MENU/SET ] button with the step 1 condition.
*The display is changed as shown below when [ MENU/SET ] button is pressed.
Menu display → Error code display → Camera information display → Menu display → .....
Example of Error Code Display
To Next Page
Loading...
Need help?
General
Weight and Dimensions
