242
Wi-Fi/Bluetooth
Preparation
Install “Image App” in advance. (→226)
→ [Setup] → [Wi-Fi] → [Wi-Fi Function] →
[New Connection] → [Send Images While Recording] /
[Send Images Stored in the Camera]
1
Connect to a smartphone
(On your smartphone)
Set Wi-Fi function to “ON”
Select the SSID displayed on this unit
Start “Image App”
2
Select the device you wish to connect to
3
Check the send settings, and select [Set]
• To change the send setting, press the [DISP.] button. (→244)
[Send Images While Recording]
4
Take a still picture (→243)
[Send Images Stored in the Camera]
4
Select the picture (→244)
●
When [Auto Transfer] in the [Bluetooth] is set to [ON], [Wi-Fi Function] is disabled.
■
Images that can be sent
JPEG RAW MP4
4K Burst File
Pictures recorded in [Post Focus]
○ ○
○
*
–
*
Excluding 4K motion pictures. Sending by [Send Images While Recording] is not available.
• Some images may not be played back or sent depending on the device.
• For more information about picture playback, see the operating instructions of the
destination device.
Sending pictures to a smartphone
To Next Page
Loading...
