Panasonic LUMIX DC-ZS99 - Copying Still Pictures and Motion Pictures

255
Connecting with other devices
Storing recorded still pictures and motion pictures on your PC
Copying still pictures and motion pictures
Preparations
• Install “PHOTOfunSTUDIO” on your computer before starting the copying procedure. (→253)
• Turn on the camera and computer.
1
Connect camera to computer
• Check the plug direction and insert it straight in. (Inserting these at an angle may cause
deformation or malfunction) Also, do not insert into the wrong socket. Doing so may cause
damage to this unit.
• Use the supplied USB connection cable or a commercially available Type-C USB connection
cable that complies with USB standards. (Depending on the country or area where the camera
was purchased, the USB connection cable may not be supplied with the camera.)
[Access]
• Do not disconnect the USB connection cable while [Access] is displayed.
[USB/CHARGE] socket
USB connection cable
2
Use “PHOTOfunSTUDIO” to copy pictures to your computer
• Do not delete or move copied files and folders using Windows Explorer or other browsers.
Otherwise, you will not be able to play back or edit the files using “PHOTOfunSTUDIO”.
●
Before inserting or removing a card, turn the camera off and disconnect the USB connection
cable. Otherwise, data may be destroyed.
●
Take care not to turn off the camera while images are being imported.
●
When the battery begins to run out during communication, a warning beep sounds. Remove the
USB connection cable safely. Otherwise, data may be destroyed.