Basic
- 26 -
Taking 3D pictures
With the two lenses built into this unit, you can record 3D pictures.
•
3D pictures are stored in MPO format. In this unit both MPO images and fine JPEG images are
recorded simultaneously.
• The following functions are activated automatically.
– [Auto] in [Sensitivity]/Auto White Balance/[Quick AF]/[i.Resolution]/[AF Assist Lamp]/
[Stabilizer]
Set the 3D/2D switch to [3D].
Aim the AF area at the point you want to focus on.
Press the shutter button halfway to focus.
A ISO sensitivity
B Aperture value
C Shutter speed
• Be careful not to get too close to the subject.
If the distance to the subject is too close, the 3D alert
indication [ ] will appear. The recommended
range for 3D recording may differ depending on the
amount of zoom. (P27)
• Make sure that your fingers are not over either of
the lenses.
During 3D recording, the image from the right-hand
lens is not displayed. If a finger etc. is covering a
lens, the 3D alert indication [ ] will appear.
• The focus indication D (green) lights when the
subject is focused.
• Aperture value and shutter speed is displayed in red
when correct exposure is not achieved. (Exclude
when using a flash)
Press the shutter button fully (push it in
further), and take the picture.
DMC-3D1PDF-VQT3U43_mst.book 26 ページ ２０１１年１０月２４日 月曜日 午後１時９分
To Next Page
Loading...
