O_e_
• This message appears when the camera is not operating properly.
Turn the camera off and on. If the message persists, contact the dealer or your nearest
Service Center.
Use a card compatible with this unit. (P17)
-SD Memory Card (8 MB to 2 GB)
-SDHC Memory Card (4 GB to 32 GB)
-SDXC Memory Card (48 GB, 64 GB)
• An error has occurred accessing the card.
Insert the card again.
Insert a different card.
• It has failed to read or write data.
Remove the card after turning the power [OFF]. Insert the card again, turn the power on,
and try to read or write the data again.
• The card may be broken.
Insert a different card.
• Use a card with SD Speed Class with "Class 6" or higher when recording motion pictures.
• In the event that it stops even after using a "Class 6" card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format (P40).
• Depending on the type of the card, motion picture recording may stop in the middle.
• A folder cannot be created because there are no remaining folder numbers that can be used.
Format the card after saving necessary data on a PC etc. (P40)
• Select [TV Aspect] in the [Setup] menu if you want to change the TV aspect. (P39)
• This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P99,
103)
-77£-
To Next Page
Loading...
