Advanced (Recording pictures)
- 52 -
∫ Shutter speed for each flash setting
¢1 The shutter speed changes depending on the [STABILIZER] (P92) setting.
¢2 When Intelligent ISO is set (P84)
• ¢1, 2: The shutter speed becomes a maximum of 1 second in the following cases.
– When the optical image stabilizer is set to [OFF].
– When the camera has determined that there is little jitter when the optical image stabilizer is
set to [MODE1], [MODE2] or [AUTO].
• In Intelligent auto mode, shutter speed changes depending on the identified scene.
• In Scene mode, shutter speed will be different from the above table.
Note
• If you bring the flash too close to an object, the object may be distorted or discoloured by the
heat or lighting from the flash.
• When you take a picture beyond the available flash range, the exposure may not be adjusted
properly and the picture may become bright or dark.
• When the flash is being charged, the flash icon blinks red, and you cannot take a picture even
when you press the shutter button fully. When [AUTO LCD OFF] is set, the LCD monitor
turns off and the status indicator lights.
• The white balance may not be properly adjusted if the flash level is insufficient for the subject.
• When the shutter speed is fast, the flash effect may not be sufficient.
• It may take time to charge the flash if you repeat taking a picture. Take a picture after the
access indication disappears.
• The red-eye reduction effect differs between people. Also, if the subject was far away from the
camera or was not looking at the first flash, the effect may not be evident.
Flash setting Shutter speed (Sec.) Flash setting Shutter speed (Sec.)
‡
1/30 to 1/2000
1 or 1/8 to 1/2000
¢1
1 or 1/4 to 1/2000
¢2
‰
Œ
To Next Page
Loading...
Need help?
General
Weight and Dimensions
