Advanced (Playback)
80
VQT1C14
Press [ ] to display the [PLAY] mode
menu and select the item to set. (P69)
Usually, it is not necessary to format the
built-in memory and the card.
Format them when the message
[BUILT-IN MEMORY ERROR] or
[MEMORY CARD ERROR] appears.
Press 3 to select [YES] and then
press [MENU/SET].
(The illustration shows the screen when
the built-in memory is formatted.)
• When a card is not inserted, you can
format the built-in memory. When a card
is inserted, you can format the card.
• If you press [MENU/SET] while
formatting the built-in memory, the
formatting will stop halfway. (However,
all the pictures will be deleted.)
• Formatting irretrievably deletes all the
data including any protected pictures.
Check the data carefully before
formatting.
• If the card has been formatted on a PC or other
equipment, format it on the camera again.
• Use a battery with sufficient battery power
(P21) or the AC adaptor (DMW-AC5PP;
optional) when formatting.
• Do not turn the camera off during
formatting.
• It may take longer to format the built-in
memory than the card. (Max. about 15 sec.)
• You cannot format an SD Memory Card or
an SDHC Memory Card when the card’s
Write- Protect switch A is set to [LOCK].
• If the built-in memory or the card cannot
be formatted, consult your nearest
Service Center.
[FORMAT]
Initializing the card
MENU
SET
MENU
SET
FORMAT
NO
YES
SELECT SET
MENU
MENU
SET
DELETE ALL DATA
ON THE BUILT-IN MEMORY?
2
For USA assistance, please call: 1-800-272-7033
or send e-mail to : digitalstillcam@us.panasonic.com
For Canadian assistance, please call:
1-800-99-LUMIX (1-800-995-8649) or
send e-mail to: lumixconcierge@ca.panasonic.com
VQT1C14ENG.book 80 ページ ２００６年１２月４日 月曜日 午後１１時０分
To Next Page
Loading...
Need help?
General
