Recording pictures (basic)
42
VQT0Q28
∫ Shutter speed for each flash setting
• Refer to P59 for the Aperture-priority AE, Shutter-priority AE or Manual exposure mode.
∫ Adjusting flash output
Adjust the flash output when the subject is
small or reflection ratio is extremely high or
low.
1 Press 3 several times until
[ FLASH] appears and then set
the flash output.
• You can adjust this from j2EV to
i2 EV in steps of 1/3 EV.
• The flash output setting is memorised
even if the camera is turned off.
• In motion image mode [ ], simple
mode [ ], [SCENERY], [NIGHT
SCENERY] or [FIREWORKS] in scene
mode (P63), you cannot adjust the flash
output.
Flash setting Shutter speed (Sec.)
: AUTO 1/60 – 1/2000
: AUTO/Red-eye reduction 1/60 – 1/2000
:Forced ON
: Forced ON/Red-eye reduction
1/60 – 1/2000
: Slow sync./Red-eye reduction 1 – 1/2000
: Forced OFF
1/4 – 1/2000
8 – 1/2000
(In [NIGHT SCENERY] in
scene mode)
FLASH
SELECT
EXIT
VQT0Q28ENG.book 42 ページ ２００５年２月１４日 月曜日 午後５時３１分
To Next Page
Loading...
