165
6. Shutter and Drive Settings
• The burst speed may become slower depending on the following settings.
– [Picture Size] (P127)/[Quality] (P128)/[Sensitivity] (P157)/Focus Mode (P135)/[Focus/
Release Priority] (P147)
• Burst speed can also be set with [Burst Rate] in the [Rec] menu.
• Refer to P128 for information about RAW files.
4
Focus on the subject and take a picture.
• Hold down the shutter button fully to activate the Burst
Mode.
∫ Cancelling the Burst Mode
Select [ ] ([Single]) or [ ] from among the drive modes. (P163)
Focusing in Burst Mode
The focus changes depending on the setting for [Focus/Release Priority] (P147) in the
[Custom] menu and the setting for [Focus Mode] (P135) in the [Rec] menu.
¢1 When the subject is dark or the burst speed is set to [SH], the focus is fixed on the first
picture.
¢2 The burst speed may become slower because the camera is continuously focusing on the
subject.
¢3 Burst speed takes priority, and focus is estimated within possible range.
Focus mode
[Focus/Release
Priority]
Focus
[AFS]
[FOCUS]
At the first picture
[RELEASE]
[AFF]/[AFC]
¢1
[FOCUS] Normal focusing
¢2
[RELEASE] Predicted focusing
¢3
[MF] — Focus set with Manual Focus
AFS
50
i
H
L
4:3
To Next Page
Loading...
