43
2. Getting Started/Basic Operations
Press [DISP.] to switch the information displayed on the
screen.
•
Screen will switch as follows:
¢ Histograms are displayed when the [Histogram] of the [Custom] menu is set to [ON].
It is also possible to display the Exposure meter by setting the [Expo.Meter] of the [Custom]
menu to [ON]. (P85)
• If approximately 1 minute elapses without an operation being performed, part of the display will
disappear.
Press [DISP.] or touch the monitor to make the display reappear.
[DISP.] button (Switching the displayed information)
In Recording Mode
With information
¢
Without
information
With information
(tilt sensor
display)
¢
Without
information (tilt
sensor display)
To Next Page
Loading...
