69
2. Getting Started/Basic Operations
Entering Text
It is possible to enter babies’ and pets’ names and the
locations when recording.
When a screen that looks like the one on the right is
displayed, you can enter characters.
(Only alphabetical characters and symbols can be entered.)
•
Example of operation for displaying a screen:
1
Press 3/4/2/1 to select text and then press [MENU/SET] to
register.
• Move the cursor to [ ] and then press [MENU/SET] to switch text between [A]
(capitals), [a] (lower case), [1] (numbers) and [&] (special characters).
• To enter the same character again, rotate the control dial right to move the cursor.
• The following operations can be performed by moving the cursor to the item and
pressing [MENU/SET]:
– []]: Enter a blank
– [Delete]: Delete a character
– [ ]: Move the entry position cursor to the left
– [ ]: Move the entry position cursor to the right
• A maximum of 30 characters can be entered.
(Maximum of 9 characters when setting names in [Face Recog.])
• A maximum of 15 characters can be entered for [ ], [ ], [ ], [ ] and [ ].
(Maximum of 6 characters when setting names in [Face Recog.])
2
Press 3/4/2/1 to move the cursor to [Set] and then press
[MENU/SET] to end text input.
• Text can be scrolled if all of the entered text does not fit on the screen.
> [Rec] > [Profile Setup] > [SET] >
[Baby1] > [Name] > [SET]
To Next Page
Loading...
