8. Stabiliser, Zoom and Flash
196
Applicable modes:
Sets the screen display and lens operations when using an interchangeable lens that is
compatible with power zoom (electrically operated zoom).
This may only be selected when using a lens that is compatible with power zoom
(electrically operated zoom).
•
The interchangeable lens (H-PS14042) is compatible with power zoom.
• The interchangeable lenses (H-FS12032/H-FS35100) are not compatible with power zoom.
(For compatible lenses, please refer to our website.)
Changing the settings for a power zoom lens
> [Custom] > [Power Zoom Lens]
[Disp Focal
Length]
When you zoom, the focal distance is
displayed and you can confirm the zoom
position.
A Focal distance indication
B Current focal distance
[ON]/[OFF]
[Step Zoom]
When you operate the zoom with this setting
[ON], the zoom will stop at positions
corresponding to predetermined distances.
C Step zoom indication
• [Step Zoom] is disabled during motion
picture recording.
[ON]/[OFF]
[Zoom Resume]
When you turn this unit on, the zoom positions when you last turned this unit
off are automatically restored.
[ON]/[OFF]
[Zoom Speed]
You can set the zoom speed for zoom operations.
• If you set [Step Zoom] to [ON], the zoom speed will not change.
[Photo]:
[H] (High speed)/[M] (Middle speed)/[L] (Low speed)
[Video]:
[H] (High speed)/[M] (Middle speed)/[L] (Low speed)
[Zoom Ring]
This may only be selected when a power zoom-compatible lens with a zoom
lever and zoom ring is attached.
When set to [OFF], the operations controlled by the zoom ring are disabled
to prevent accidental operation.
[ON]/[OFF]
To Next Page
Loading...
