11. Using the Wi-Fi function
258
∫ Changing the connection method
To change the connection method, follow the steps below:
When connecting with [Via Network]:
1 Select [Via Network].
•
Follow the connection procedure described on P288 to connect the camera to a wireless
access point.
2 Turn on the Wi-Fi function.
3 Connect the smartphone to the wireless access point to which the camera is
connected.
4 Start “Image App”. (P253)
When connecting with [WPS Connection]
¢
in [Direct]:
1 Select [Direct].
•
Follow the connection procedure described on P290 to connect the camera to the
smartphone.
2 Start “Image App”. (P253)
¢ WPS is a function that allows you to easily set up a connection with a wireless LAN device
and make security-related settings. To check whether your smartphone supports the
function, refer to the operating instructions of the smartphone.
∫ Terminating the connection
After use, terminate the connection to the smartphone.
1 Press [Wi-Fi] on the camera. (P250)
(You can also terminate the connection by performing the following operations on the
recording screen: > [Setup] > [Wi-Fi] > [Wi-Fi Function] > [Yes].)
2 On the smartphone, close “Image App”.
> [DISP.] button > [New Connection] >
[Remote Shooting & View] > [DISP.] button
On the camera
On your smartphone
On the camera
On your smartphone
(If you are using an iOS device)
On the screen of “Image App”, press the home button to close the app.
(If you are using an Android device)
On the screen of “ Image App”, press the return button twice to close the app.
To Next Page
Loading...
